Question

3d model is not been placed properly.

Comments

NaN 3, NH 4 Cl, DMF, 12 h, reflux; ii <a href=https://fastpriligy.top/>priligy dapoxetine</a>

---

CDB 4124 21 methoxy 17О± acetoxy 11ОІ 4 N, N dimethylaminophenyl 19 norpregna 4, 9 diene 3, 20 dione with the following structural formula <a href=https://clomid2buy.top/>clomid order</a> The pharmacokinetics of enclomiphene citrate over 24 h differ from the LH and testosterone patterns, emphasizing the likelihood that enclomiphene citrate affects biological mechanisms that persist after serum levels of enclomiphene citrate fall

Answer 1

First of all, make sure that your model is placed at 0,0,0 in position Then scale down your model so that it fits in your dev cube. You can change both in the inspector Change position in "y", start with 1 and go to an inspector to check when it comes above the IMG target then decrease the size accordingly.